Metes and bounds is a system or method of describing land, real property (in contrast to personal property) or real estate. The system has been used in England for many centuries and is still used there in the definition of general boundaries. The system is also used in the Canadian province of Ontario, and throughout Canada for the description of electoral districts. By custom, it was applied in the original Thirteen Colonies that became the United States, and in many other jurisdictions that adopted land administration and legal practice based on English common law, including Zimbabwe, South Africa, India and Bangladesh. While still in hand-me-down use, this system has been largely overtaken in the past few centuries by newer systems such as rectangular (government survey) and lot and block (recorded plat). Typically the system uses physical features of the local geography, along with directions and distances, to define and describe the boundaries of a parcel of land. The boundaries are described in a running prose style, working around the parcel in sequence, from a point of beginning, returning to the same point, comparable with the oral ritual of beating the bounds. It may include references to other adjoining parcels (and their owners), and it, in turn, could also be referred to in later surveys. At the time the description is compiled, it may have been marked on the ground with permanent monuments placed where there were no suitable natural monuments.
Metes refers to boundaries defined by the measurement of straight runs, specified by a distance between the terminal points, and an orientation or direction. A direction may be a simple compass bearing or a precise orientation determined by accurate survey methods. Bounds (Abuttals and boundaries) refers to more general boundary descriptions, such as along a certain watercourse, a stone wall, an adjoining public road way, or an existing building. The system is often used to define larger pieces of property (e.g. farms) and political subdivisions (e.g. town boundaries) where precise definition is not required or would be far too expensive, or previously designated boundaries can be incorporated into the description.
Usage
A typical description for a small parcel of land would be: "Commencing at a corner at the intersection of two stone walls near an apple tree on the north side of Muddy Creek road one mile above the junction of Muddy and Indian Creeks, thence north for 150 rods to the end of the stone wall bordering the road, thence northwest along a line to a large standing rock on the corner of the property now or formerly belonging to John Smith, thence west 150 rods to the corner of a barn near a large oak tree, thence south to Muddy Creek road, thence down the side of the creek road to the point of commencement."This sample description sequence begins with an identified corner serving as benchmark. The description then gives distance, direction and various boundary descriptions as if one were walking the bounds pacing off the distance to the next corner where there is a change of direction. Where watercourses form part of the bounds their meander is generally taken as a straight line between the established corners and their monuments. In many deeds, the direction is described not by azimuth (a clockwise degree measure out of 360 degrees) but instead by bearing (a direction north or south followed by a degree measure out of 90 degrees and another direction west or east). For example, such a bearing might be listed as "N 42°35′ W", which means that the bearing is 42°35′ counterclockwise, or west of north. This has the advantage of providing the same degree measure regardless of which direction a particular boundary is being followed; the boundary can be traversed in the opposite direction simply by exchanging N for S and E for W. In other words, "N 42°35′ W" describes the same boundary as "S 42°35′ E" but is traversed in the opposite direction. In most distance measures, especially those in older deeds and where measuring distances over a furlong, boundary lengths are listed in rods or poles instead of feet or meters. Rods and poles are equivalent measures equaling 16.5 feet. There are four rods in one chain. English surveyors carried chains (such as a Gunter's chain) with which to measure lengths, as well as poles, and many older legal descriptions of real estate in the United States are given in chains and poles.
Resolving inconsistencies Some courts have established a list of priorities to resolve inconsistent descriptions of corners. In descending order starting with the most reliable: (1) natural monuments, (2) artificial monuments such as roads and marked or surveyed lines, (3) adjacent tracts or boundaries, (4) courses or directions, (5) distances, and (6) area or quantity.
… excerpt ends here. Continue reading the full article.
