Photosynthetically active radiation (PAR) designates the spectral range (wave band) of solar radiation from 400 to 700 nanometers that photosynthetic organisms are able to use in the process of photosynthesis. This spectral region corresponds more or less with the range of light visible to the human eye. Photons at shorter wavelengths tend to be so energetic that they can be damaging to cells and tissues, but are mostly filtered out by the ozone layer in the stratosphere. Photons at longer wavelengths do not carry enough energy to allow photosynthesis to take place. Other living organisms, such as cyanobacteria, purple bacteria, and heliobacteria, can exploit solar light in slightly extended spectral regions, such as the near-infrared. These bacteria live in environments such as the bottom of stagnant ponds, sediment and ocean depths. Because of their pigments, they form colorful mats of green, red and purple.
Chlorophyll, the most abundant plant pigment, is most efficient in capturing red and blue light. Accessory pigments such as carotenes and xanthophylls harvest some green light and pass it on to the photosynthetic process, but enough of the green wavelengths are reflected to give leaves their characteristic color. An exception to the predominance of chlorophyll is autumn, when chlorophyll is degraded (because it contains N and Mg) but the accessory pigments are not (because they only contain C, H and O) and remain in the leaf producing red, yellow and orange leaves. In land plants, leaves absorb mostly red and blue light in the first layer of photosynthetic cells because of chlorophyll absorbance. Green light, however, penetrates deeper into the leaf interior and can drive photosynthesis more efficiently than red light. Because green and yellow wavelengths can transmit through chlorophyll and the entire leaf itself, they play a crucial role in growth beneath the plant canopy. PAR measurement is used in agriculture, forestry and oceanography. One of the requirements for productive farmland is adequate PAR, so PAR is used to evaluate agricultural investment potential. PAR sensors stationed at various levels of the forest canopy measure the pattern of PAR availability and utilization. Photosynthetic rate and related parameters can be measured non-destructively using a photosynthesis system, and these instruments measure PAR and sometimes control PAR at set intensities. PAR measurements are also used to calculate the euphotic depth in the ocean. In these contexts, the reason PAR is preferred over other lighting metrics such as luminous flux and illuminance is that these measures are based on human perception of brightness, which is strongly green biased and does not accurately describe the quantity of light usable for photosynthesis.
Units
When measuring the irradiance of PAR, values are expressed using units of energy (W/m2), which is relevant in energy-balance considerations for photosynthetic organisms. However, photosynthesis is a quantum process and the chemical reactions of photosynthesis are more dependent on the number of photons than the energy contained in the photons. Therefore, plant biologists often quantify PAR using the number of photons in the 400-700 nm range received by a surface for a specified amount of time, or the Photosynthetic Photon Flux Density (PPFD). Values of PPFD are normally expressed using units of mol⋅m−2⋅s−1. In relation to plant growth and morphology, it is better to characterise the light availability for plants by means of the Daily Light Integral (DLI), which is the daily flux of photons per ground area, and includes both diurnal variation as well as variation in day length. PPFD used to sometimes be expressed using einstein units, i.e., μE⋅m−2⋅s−1, although this usage is nonstandard and is no longer used.
Light fixture efficiency
Yield photon flux
There are two common measures of photosynthetically active radiation: photosynthetic photon flux (PPF) and yield photon flux (YPF). PPF values all photons from 400 to 700 nm equally, while YPF weights photons in the range from 360 to 760 nm based on a plant's photosynthetic response. PAR as described with PPF does not distinguish between different wavelengths between 400 and 700 nm, and assumes that wavelengths outside this range have zero photosynthetic action. If the exact spectrum of the light is known, the photosynthetic photon flux density (PPFD) values in μmol⋅s−1⋅m−2) can be modified by applying different weighting factors to different wavelengths. This results in a quantity called the yield photon flux (YPF). The red curve in the graph shows that photons around 610 nm (orange-red) have the highest amount of photosynthesis per photon. However, because short-wavelength photons carry more energy per photon, the maximum amount of photosynthesis per incident unit of energy is at a longer wavelength, around 650 nm (deep red). It has been noted that there is considerable misunderstanding over the effect of light quality on plant growth. Many manufacturers claim significantly increased plant growth due to light quality (high YPF). The YPF curve indicates that orange and red photons between 600 and 630 nm can result in 20 to 30% more photosynthesis than blue or cyan photons between 400 and 540 nm.
But the YPF curve was developed from short-term measurements made on single leaves in low light. More recent longer-term studies with whole plants in higher light indicate that light quality may have a smaller effect on plant growth rate than light quantity. Blue light, while not delivering as many photons per joule, encourages leaf growth and affects other outcomes. The conversion between energy-based PAR and photon-based PAR depends on the spectrum of the light source (see Photosynthetic efficiency). The following table shows the conversion factors from watts for black-body spectra that are truncated to the range 400–700 nm. It also shows the luminous efficacy for these light sources and the fraction of a real black-body radiator that is emitted as PAR.
… excerpt ends here. Continue reading the full article.
