A supercritical fluid (SCF) is a substance at a temperature and pressure above its critical point, where distinct liquid and gas phases do not exist, but below the pressure required to compress it into a solid. It can effuse through porous solids like a gas, overcoming the mass transfer limitations that slow liquid transport through such materials. SCFs are superior to gases in their ability to dissolve materials like liquids or solids. Near the critical point, small changes in pressure or temperature result in large changes in density, allowing many properties of a supercritical fluid to be "fine-tuned". Supercritical fluids occur in the atmospheres of the gas giants Jupiter and Saturn, the terrestrial planet Venus, and probably in those of the ice giants Uranus and Neptune. Supercritical water is found on Earth, such as the water issuing from black smokers, a type of hydrothermal vent. SCFs are used as a substitute for organic solvents in a range of industrial and laboratory processes, most commonly carbon dioxide for decaffeination and water for steam boilers for power generation. Some substances are soluble in the supercritical state of a solvent (e.g., carbon dioxide) but insoluble in the gaseous or liquid state—or vice versa. This can be used to extract a substance and transport it elsewhere in solution before depositing it in the desired place by allowing or inducing a phase transition in the solvent.
Properties Supercritical fluids generally have properties between those of a gas and a liquid. In Table 1, the critical properties are shown for some substances that are commonly used as supercritical fluids.
Table 2 shows density, diffusivity and viscosity for typical liquids, gases and supercritical fluids.
Also, there is no surface tension in a supercritical fluid, as there is no liquid/gas phase boundary. By changing the pressure and temperature of the fluid, the properties can be "tuned" to be more liquid-like or more gas-like. One of the most important properties is the solubility of material in the fluid. Solubility in a supercritical fluid tends to increase with density of the fluid (at constant temperature). Since density increases with pressure, solubility tends to increase with pressure. The relationship with temperature is a little more complicated. At constant density, solubility will increase with temperature. However, close to the critical point, the density can drop sharply with a slight increase in temperature. Therefore, close to the critical temperature, solubility often drops with increasing temperature, then rises again.
Mixtures Typically, supercritical fluids are completely miscible with each other, so that a binary mixture forms a single gaseous phase if the critical point of the mixture is exceeded. However, exceptions are known in systems where one component is much more volatile than the other, which in some cases form two immiscible gas phases at high pressure and temperatures above the component critical points. This behavior has been found in systems such as N2-NH3, NH3-CH4, SO2-N2 and n-butane-H2O.. The systems composed by a supercritical fluid and a liquid are named Gas expanded liquids. The critical point of a binary mixture can be estimated as the arithmetic mean of the critical temperatures and pressures of the two components,
where χi denotes the mole fraction of component i. For greater accuracy, the critical point can be calculated using equations of state, such as the Peng–Robinson, or group-contribution methods. Other properties, such as density, can also be calculated using equations of state.
Phase diagram
… excerpt ends here. Continue reading the full article.
