ArticleslgStudy

engineering

Sympathetic detonation

Sympathetic detonation is a engineering topic covered in the lgStudy science library. This page brings together a partial reference excerpt, illustrations, worked examples, real-world applications and a short study plan, so you can understand Sympathetic detonation rather than just read about it. In short: A sympathetic detonation (SD, or SYDET), also called flash over or secondary/secondaries (explosion), is a detonation, usually unintended, of an explosive charge by a nearby explosion. Definition A sympathetic detonation is caused by a shock wave, or impact of primary or secondary blast fragments.

Key takeaways

  • Sympathetic detonation belongs to engineering; place it in that map before memorising details.
  • Learn the definition first, then one example that makes the definition concrete.
  • Connect Sympathetic detonation to a quantity you can measure, compute or draw — that is where exam questions come from.
  • Reproduce the core statement of Sympathetic detonation from memory before moving on to harder problems.

Reference excerpt

A sympathetic detonation (SD, or SYDET), also called flash over or secondary/secondaries (explosion), is a detonation, usually unintended, of an explosive charge by a nearby explosion.

Definition A sympathetic detonation is caused by a shock wave, or impact of primary or secondary blast fragments. The initiating explosive is called the donor explosive, the initiated one is known as the receptor explosive. In case of a chain detonation, a receptor explosive can become a donor one. The shock sensitivity, also called gap sensitivity, which influences the susceptibility to sympathetic detonations, can be measured by gap tests. If detonators with primary explosives are used, the shock wave of the initiating blast may set off the detonator and the attached charge. However even relatively insensitive explosives can be set off if their shock sensitivity is sufficient. Depending on the location, the shock wave can be transported by air, ground, or water. The process is probabilistic, a radius with 50% probability of sympathetic detonation often being used for quantifying the distances involved. Sympathetic detonation presents problems in storage and transport of explosives and ordnance. Sufficient spacing between adjacent stacks of explosive materials has to be maintained. In case of an accidental detonation of one charge, other ones in the same container or dump can be detonated as well, but the explosion should not spread to other storage units. Special containers attenuating the shock wave can be used to prevent the sympathetic detonations; epoxy-bonded pumice liners were successfully tested. Blow-off panels may be used in structures, e.g. tank ammunition compartments, to channel the explosion overpressure in a desired direction to prevent a catastrophic failure. Other factors causing unintended detonations are e.g. flame spread, heat radiation, and impact of fragmentation. A related term is cooking off, setting off an explosive by subjecting it to sustained heat of e.g. a fire or a hot gun barrel. A cooked-off explosive may cause sympathetic detonation of adjacent explosives.

Military Sympathetic detonations may occur in munitions stored in e.g. vehicles, ships (called a Magazine Explosion), gun mounts, or ammunition depot, by a sufficiently close explosion of a projectile or a bomb. Such detonations after receiving a hit have caused many catastrophic losses of vehicles. To prevent sympathetic detonations, minimal distances (specific for a given type of the mine) have to be maintained between mines when laying a minefield. Spallation of materials after an impact on the opposite side may create fragments capable of causing sympathetic detonations of stored explosives on the opposite side of an armour plate or a concrete wall. Transfer of the shock wave through the wall or armour may also be possible cause of a sympathetic detonation. Class 1.1 solid rocket fuels are susceptible to sympathetic detonation. Conversely, class 1.3 fuels can be ignited by a nearby fire or explosion, but are generally not susceptible to sympathetic detonation. Class 1.1 fuels, however, tend to have slightly higher specific impulses, and therefore are used in those military applications where weight and/or size is at a premium, e.g. on ballistic and cruise missile submarines. Sympathetic detonation can be used for the destruction of unexploded ordnance, improvised explosive devices, land mines, or naval mines by an adjacent bulk charge. Special insensitive explosives, such as TATB, are used in certain military applications to avoid sympathetic detonations.

Examples During the Attack of Pearl Harbor, the USS Arizona was struck with an armor-piercing bomb which penetrated the upper deck and stopped inside the forward magazine. The bomb triggered an explosion which was powerful enough to cut the Arizona in half and is considered a sympathetic detonation as there was an apparent delay between the detonation of the bomb and the contents of the forward magazine. Sympathetic detonation killed 320 sailors and injured 390 others in the Port Chicago Disaster of July 17, 1944 at the Port Chicago Naval Magazine in Port Chicago, California. During the 1967 USS Forrestal fire, eight old Composition B based iron bombs cooked off. The last one caused a sympathetic detonation of a ninth bomb, a more modern and less cookoff-susceptible Composition H6 based one. The Russian submarine Kursk explosion was probably caused by a sympathetic explosion of several torpedo warheads. A single dummy torpedo VA-111 Shkval exploded; 135 seconds later a number of warheads simultaneously exploded and sank the submarine. Multiple incidents have been recorded in the more recent GWoT where airstrikes have set off explosives or ammunition caches in insurgent positions.

Civilian In rock blasting, sympathetic detonations occur when the blastholes are sufficiently close to each other, usually 24in or less, and especially in rocks that poorly attenuate the shock energy. Ground water in open channels facilitates sympathetic detonation as well. Blasthole spacing of 36in or more is suggested. However, in some ditch blasting cases sympathetic detonations are exploited purposefully. Nitroglycerine-based explosives are especially susceptible. Picric acid is sensitive as well. Water gel explosives, slurry explosives, and emulsion explosives tend to be insensitive to sympathetic detonations. For most industrial explosives, the maximum distances for possible sympathetic detonations are between 2–8 times of the charge diameter. Uncontrolled sympathetic detonations may cause excessive ground vibrations and/or flying rocks. The spread of shock waves can be hindered by placing relief holes – drilled holes without explosive charges – between the blastholes. The opposite phenomenon is dynamic desensitization (also called, Dead Pressing). Some explosives, e.g. ANFO, show reduced sensitivity under pressure. A transient pressure wave from a nearby detonation may compress the explosive sufficiently to make its initiation fail. This can be prevented by introducing sufficient delays into the firing sequence. A sympathetic detonation during mine blasting may influence the seismic signature of the blast, by boosting the P-wave amplitude without significantly amplifying the surface wave.

See also Cooking off

References

Worked examples

Example 1 — a first encounter with Sympathetic detonation

Start with the simplest possible case. Write down what Sympathetic detonation claims or describes in one sentence, then invent the smallest concrete situation in which that sentence is true. In engineering, the smallest case is usually a single object, a single equation or a single measurement. Check that every symbol or term in your sentence has a meaning in that case.

Example 2 — changing one variable

Take the situation from Example 1 and change exactly one quantity: double it, halve it, or set it to zero. Predict what should happen to Sympathetic detonation before you calculate. Comparing your prediction with the result is the fastest way to find out whether you understand the idea or only the words.

Example 3 — an exam-style question

Typical questions about Sympathetic detonation ask you to (a) state it precisely, (b) apply it to given data, and (c) explain a limitation. Practise writing all three answers in under five minutes; the third part is what separates a full-mark answer from an average one.

Applications of Sympathetic detonation

In research
Sympathetic detonation appears in engineering research whenever the underlying quantities have to be modelled precisely. Papers usually cite it as a starting assumption and then explore where it breaks down.
In technology and industry
Engineering practice reuses Sympathetic detonation in design rules, simulations and safety margins. Knowing the idea lets you read a specification sheet and understand why the numbers look the way they do.
In the classroom
Sympathetic detonation is common in secondary-school and first-year university syllabi. It links to neighbouring topics Explosions, Explosives engineering, so understanding it makes those chapters shorter.
In everyday life
Look for Sympathetic detonation outside the textbook — in sport, cooking, traffic, electronics or the sky above you. An example you found yourself is remembered far longer than one you were given.
Ask Teacher Smith questions about this articleOpens your AI tutor with a question about “Sympathetic detonation” →

Affiliate

Preply — study more efficiently by working with a personal tutor. 50% off.

How to study Sympathetic detonation in 20 minutes

  1. Read the reference excerpt below once, without taking notes.
  2. Close the page and write down what Sympathetic detonation means in your own words.
  3. Compare your version with the excerpt and mark what you missed.
  4. Work through the three examples above with pen and paper.
  5. Explain Sympathetic detonation out loud to somebody else — or to Teacher Smith in the lgStudy chat.

Frequently asked questions

What is Sympathetic detonation in simple terms?

A sympathetic detonation (SD, or SYDET), also called flash over or secondary/secondaries (explosion), is a detonation, usually unintended, of an explosive charge by a nearby explosion. Definition A sympathetic detonation is caused by a shock wave, or impact of primary or secondary blast fragments.

Why does Sympathetic detonation matter?

Because it connects several engineering ideas at once: it gives you a definition you can apply, a quantity you can calculate, and a way to check whether a result is plausible.

How should I study Sympathetic detonation?

Read the excerpt, restate it from memory, then work through the examples and applications listed on this page. The five-step study plan above takes about twenty minutes.

What does this page cover?

It gives you a compact reference excerpt plus original lgStudy explanations, examples, applications and study material on Sympathetic detonation.

Tags

  • Explosions
  • Explosives engineering

Keep exploring